LightWare SF20/C comparison guide

Independent evaluation guide — not an official LightWare document. Keyword pairing does not establish equivalence. Source completeness does not establish compatibility or a current commercial offer.

Comparing like-for-like evidence

This LightWare SF20/C comparison with ERDI LRF1500H is an evaluation worksheet, not a declaration that the devices are equivalent. Begin by checking what each device actually outputs and what the host system needs. Different sensing architectures can serve different tasks even when their product descriptions share distance-related vocabulary. The supplied keyword association alone is not evidence of comparable coverage or suitability.

Use original source documents for both columns and keep every value attached to its test conditions. Compare range against the same target assumptions, accuracy against the same distance interval and update behavior against the same operating mode. Do not substitute a peak value for a sustained value or silently mix data from different revisions. Where the evidence is missing, the honest result is an unresolved field.

Review the complete integration boundary: electrical levels, connector orientation, protocol framing, mounting datum, operating environment and error reporting. Assign a test to every requirement that documents alone cannot settle. A final selection should follow a recorded engineering review and a representative prototype evaluation, not a count of favorable cells in a table. Contact ERDI with the worksheet to establish which candidate configuration should be assessed.

Source-gated comparison

Competitor values use the supplied source URL, capture date and confidence record; ERDI values additionally require a matching source excerpt. Capture dates record retrieval, not publication or revision dates. Missing or unsupported entries stay marked as Not published, describing a gap in the supplied evidence rather than an exhaustive vendor search.

LightWare SF20/C | ERDI LRF1500H | parameter verification
ParameterLightWare SF20/CERDI LRF1500H
Measurement range (m)0.2-1000.05-1500 m (90% reflectivity); 0.05-300 m (10% reflectivity)
Accuracy (cm)5±10 cm (<10 m); 1% (≥10 m)
Update rate (Hz)48-5000Not published
Electrical interface and protocolUSB/UART/I2CUART/IIC
Supply voltage (V)4.5-5.59-36 V DC
Wavelength (nm)905Not published
Field of view (deg)Not publishedNot published
Published price (USD)319.0Not published

Evidence and limitations

LightWare SF20/C source record

Source: https://lightwarelidar.com/wp-content/uploads/2025/12/SF20-Product-Guide-V13.3.pdf (captured , confidence high)

ERDI LRF1500H source record

SOURCE_URL: https://erdilrf.com/models/lrf1500h/
CAPTURED_AT:

0.05-1500 m (90% reflectivity); 0.05-300 m (10% reflectivity) | ±10 cm (<10 m); 1% (≥10 m) | UART/IIC | 9-36 V DC | 33 × 34 × 18 mm

Frequently asked questions

Is the SF20/C comparison based on verified measurements?

No independent side-by-side test is supplied. The table distinguishes source-backed entries from verification gaps, and the evaluation must use comparable targets, conditions and operating modes.

Why are some SF20/C comparison cells marked Not published?

The supplied parameter record lacks a usable value or complete source metadata. ERDI entries additionally require a supporting source excerpt. These are evidence gaps in this record, not zero values and not proof that the feature is absent.

How do I ask ERDI about LRF1500H?

Use the model link to review the candidate, then send the intended application, target conditions, host interface and quantity through the contact page. Request the applicable documents and a scoped assessment rather than assuming compatibility.

Discuss the ERDI candidate

Provide the required measurement function and operating conditions so the candidate can be assessed against the application. Model names and this planning association alone do not constitute a compatibility recommendation.