Independent evaluation guide — not an official Slamtec document. Keyword pairing does not establish equivalence. Source completeness does not establish compatibility or a current commercial offer.
Comparing like-for-like evidence
This Slamtec RPLIDAR A2M12 comparison with ERDI SPD1200ZG is an evaluation worksheet, not a declaration that the devices are equivalent. Begin by checking what each device actually outputs and what the host system needs. Different sensing architectures can serve different tasks even when their product descriptions share distance-related vocabulary. The supplied keyword association alone is not evidence of comparable coverage or suitability.
Use original source documents for both columns and keep every value attached to its test conditions. Compare range against the same target assumptions, accuracy against the same distance interval and update behavior against the same operating mode. Do not substitute a peak value for a sustained value or silently mix data from different revisions. Where the evidence is missing, the honest result is an unresolved field.
Review the complete integration boundary: electrical levels, connector orientation, protocol framing, mounting datum, operating environment and error reporting. Assign a test to every requirement that documents alone cannot settle. A final selection should follow a recorded engineering review and a representative prototype evaluation, not a count of favorable cells in a table. Contact ERDI with the worksheet to establish which candidate configuration should be assessed.
Source-gated comparison
Competitor values use the supplied source URL, capture date and confidence record; ERDI values additionally require a matching source excerpt. Capture dates record retrieval, not publication or revision dates. Missing or unsupported entries stay marked as Not published, describing a gap in the supplied evidence rather than an exhaustive vendor search.
Slamtec RPLIDAR A2M12 | ERDI SPD1200ZG | parameter verification
Parameter
Slamtec RPLIDAR A2M12
ERDI SPD1200ZG
Measurement range (m)
0.2-12
0.1–1200 m
Accuracy (cm)
Not published
±0.5 m at d ≤100 m; ±(0.5 m + 0.0007d) for 100 m < d <1200 m
0.1–1200 m | ±0.5 m at d ≤100 m; ±(0.5 m + 0.0007d) for 100 m < d <1200 m | UART-TTL; customizable | 3.3–5 V | 7.2 × 14.7 × 22.3 mm (body; excludes mounting features)
Frequently asked questions
Is the RPLIDAR A2M12 comparison based on verified measurements?
No independent side-by-side test is supplied. The table distinguishes source-backed entries from verification gaps, and the evaluation must use comparable targets, conditions and operating modes.
Why are some RPLIDAR A2M12 comparison cells marked Not published?
The supplied parameter record lacks a usable value or complete source metadata. ERDI entries additionally require a supporting source excerpt. These are evidence gaps in this record, not zero values and not proof that the feature is absent.
How do I ask ERDI about SPD1200ZG?
Use the model link to review the candidate, then send the intended application, target conditions, host interface and quantity through the contact page. Request the applicable documents and a scoped assessment rather than assuming compatibility.
Discuss the ERDI candidate
Provide the required measurement function and operating conditions so the candidate can be assessed against the application. Model names and this planning association alone do not constitute a compatibility recommendation.